Disassembling the ML10X
Remove the 4 screws holding the back plate and remove the back plate on the ML10X
Use a pair of tweezers or small screw driver to push the connector up to remove it.
Slightly loosen the 12 nuts on the audio jacks of the ML10X
Push the circuit board out and then slide it out towards the right. You might need to wriggle it out.
After which, you can loosen the nuts on the audio jacks and remove the audio jacks. Do note that each audio jack circuit board is different, so if you are replacing this part, please make sure you are using the correct board.
Use a pair of tweezers or small screw driver to push the connector up to remove it.
Slightly loosen the 12 nuts on the audio jacks of the ML10X
Push the circuit board out and then slide it out towards the right. You might need to wriggle it out.
After which, you can loosen the nuts on the audio jacks and remove the audio jacks. Do note that each audio jack circuit board is different, so if you are replacing this part, please make sure you are using the correct board.
Updated on: 05/03/2025
Thank you!