Articles on: MIDI Controllers

Controller works fine when connected to Editor but cannot change banks once disconnected

If you have no issues using the controller while the Controller is connected to the Editor, but you start facing issues with banking up or down once you disconnected from the Editor, it is likely because the Custom Bank Arrangement feature (under Controller Settings >> Bank Arrangement) is turned ON and the Custom Bank Sequence is empty.



This behaviour occurs because when the Controller is connected to the Editor, the Custom Bank Arrangement feature will be disabled to allow you to have access to all banks for editor. Once the Controller is disconnected from the Editor, the Custom Bank Arrangement feature will be enabled again (if the feature is turned on), and the bank changes will then follow the Custom Bank Sequence.

Updated on: 05/04/2024

Was this article helpful?

Share your feedback

Cancel

Thank you!