Issue routing Input Ring signal in Simple Mode
This could be due to the experimental Input Split feature that was added in the ML10X rev-b firmware and may have been enabled by default in some batches.
This feature allows you to run a stereo signal in Simple Mode with a mono input (Input Tip) by splitting the Input Tip signal into 2 and discarding the Input Ring signal.
This feature can be turned off. In the ML10X menu, go to Global Config >> Set Input Split and then select Input Ring.
This feature allows you to run a stereo signal in Simple Mode with a mono input (Input Tip) by splitting the Input Tip signal into 2 and discarding the Input Ring signal.
This feature can be turned off. In the ML10X menu, go to Global Config >> Set Input Split and then select Input Ring.
Updated on: 16/12/2023
Thank you!